BONEYARD: P90 Stainless Steel Cutoff Lever
BONEYARD. Manufacturing defects near the sector gear cam. Slight warping. May require minor grinding or sanding in this area to fit.
SR Airsoft redesigned the P90 cutoff lever for better performance and durability. 3D printed in solid 17-4PH Stainless Steel, this has higher hardness, stiffness, and strength than any other cutoff lever. Spring and small screw included.
Styles:
TM - Compatible with any TM-based P90, which covers pretty much every single P90 that’s not the G&G or Krytac. Compatible with the stock trigger unit or our M-Triggers. Use this for installing an M-Trigger Gen 4 on the Krytac P90.
G&G - Only compatible with G&G P90’s. Compatible with the stock trigger unit or our M-Triggers.
Krytac - Only compatible with Krytac P90’s stock ETU. Do not use with M-Trigger Gen 4.
Installation:
Loctite or thread tape required. Do NOT tighten all the way down as you would the stock cutoff lever. Only tighten enough to prevent wobble while still allowing the cutoff lever to move easily. Use loctite or thread tape to prevent backing out.